It being a long weekend I thought I'd try an fix something with my Pi Econet Bridge... a proper case! This is my first proper 3D print design so I'm sure it is not perfect, but I think it looks rather swish! It's designed to fit in a half-height 5.25" disk drive case, simply as I had one lying around. It was built in Bambu Studio and printed on an A1 with AMS and 0.2mm hotend.
The actual bridge is mounted directly on the 5.25" case as mounting it on the fascia base would have raised it's height and it's already quite a tight fit in the half-height case. I may come back to that as it would be more convenient to have everything as a single part.
I'm sure it's not much use to anyone here as it's my first attempt and very rough because of it, but just in case here's the 3MF file. Maybe you can improve on it - if so, please share![:-)]( "Smile")
The actual bridge is mounted directly on the 5.25" case as mounting it on the fascia base would have raised it's height and it's already quite a tight fit in the half-height case. I may come back to that as it would be more convenient to have everything as a single part.
I'm sure it's not much use to anyone here as it's my first attempt and very rough because of it, but just in case here's the 3MF file. Maybe you can improve on it - if so, please share
Statistics: Posted by dhoggan — Tue May 06, 2025 12:22 pm