I was looking through the schematic for the original Atom Colour Board. I was hoping someone might help out with a few clarifications.
Having never seen an physical colour board I assume that it connects to the atom by desocketing the 6847 in IC31 plugging in there and resocketing the 6847 into the colour board.
1. Where are the following connections in red made on the ATOM? Are they from the 6847, the expansion bus or somewhere else?
2. What is REG1 in green in the above?
3. I assume the termination point in red below is supposed to go somewhere. Where should it go?
Attached is the full schematic for reference.
Cheers
Simon
Having never seen an physical colour board I assume that it connects to the atom by desocketing the 6847 in IC31 plugging in there and resocketing the 6847 into the colour board.
1. Where are the following connections in red made on the ATOM? Are they from the 6847, the expansion bus or somewhere else?
2. What is REG1 in green in the above?
3. I assume the termination point in red below is supposed to go somewhere. Where should it go?
Attached is the full schematic for reference.
Cheers
Simon
Statistics: Posted by sfalvey — Tue Jun 04, 2024 2:03 am